View My Cart
When You Spend $49 or More*
Stock Status:In Stock
Make short bungees to perfectly fit your Soft Straps
This simple kit lets you make four short bungees to perfectly fit your Gear Jack Soft Strap Setup.
Here's how to do it.
easure the length of the bungee from each tie down point along the path the bungee will take
Subtract 2" (1" for each end hook)
Depending on how tight you want the bungee, multiply the figure in #2 above by:
.9 for a light hold
.75 for a firm hold
.6 for a tight hold
Cut the shock cord to length. (Since you can always cut off more, it's best to start with the cord a bit long.)
Seal any frayed ends of the shock cord with a flame or heat gun
Slide the round ferrule over the end of the shock cord and press an end hook onto the cord. Fully seat the end of the cord into the hook.
With slip joint pliers, carefully squeeze the ferrule over the end hook.
Test the fit. If you want to make the bungee tighter, use the pliers to pull the ferrule off the end hook, trim the shock cord, and repeat steps 4-7. Enjoy!
36" Black 1/4" Shock Cord
8 re-usable end hooks
Other products you might be interested in...
Gear Jack Strut Support Assembly - Standard
Gear Jack Headless Stanchion Assembly - Standard
Gear Jack Fuselage Support Assembly - Standard
Joining Plate for Gladiator® Gear Track
40" Soft Strap Kit
Gear Jack 12" DIY Fuselage Support Bracket
Gear Jack 20" DIY Fuselage Support Bracket
Share your knowledge of this product.
Be the first to write a review »
Original Skid Clamps
Goblin Skid Clamps
Skid Clamp Parts
Hardware & Accessories
Skid Clamp 101
How Skid Clamps Work
Skid Clamp Quick Tips
What Size Fits My Heli?
Skid Clamp Tech Specs
Gear Jacks 101
The Gear Jacks Story
How Gear Jacks Work
Gear Jacks Tech Specs
Gear Jack Gallery
Skid Clamp Gallery
Send Us Your Pics!
Skid Clamp Support
Goblin Clamp Mounting
T-Track Platform Build
Mods You Can Do
Fast Order Form
Where to Buy
Made in USA